Hi all,
I'm new to the QM system, and have been running into an issue with QE51N. When I add a production order through the dynamic selections, it comes up with the message of 'No entries found'
Here's what I know so far:
-I've tried both production type PP01 and ZPIO
-The status in CO03 is 'REL PRT PRC ILAS MACM SETC'
-The inspection lot system status in QA03 is 'REL CALC'
-All inspection characteristics are released as seen in QS24
-In MM03, the material number's inspection setup is activated (e.g. InspType is set to 03, and set to check characteristics)
-CA03 is listing all inspection characteristics on the routing. usage is 1, status is 4
I've got to be missing something that is causing this to not work, and I ran out of ideas a long time ago. Please advise if I need to further clarify the current state, and specifically what I should try to alleviate the problem (again, relatively new to QM so I might have missed something completely obvious)
Any help would be greatly appreciated, thanks!